Page 1 of 1
Getting an issue with arducopter.. Failed to update firmware
Posted: Fri Jul 19, 2024 12:01 pm
by Priyanka Dixit
I am using arducopter with mission planner version 1.3.81, however it fails to connect and displays the error 'No heartbeat packets received'. In an attempt to fix the problem, I tried to install the firmware, but it says that the upload was unsuccessful and shows, failed to detect port. Is there a way to fix these issue and get the board to function?
Re: Getting an issue with arducopter.. Failed to update firmware
Posted: Fri Jul 19, 2024 6:02 pm
by AlamKhan
If you encounter a "heartbeat packets not received" error, there are typically four possible reasons:
1) The baudrate might be incorrect or doesn't match the APM.
2) There could be a defect in the board or damage due to incorrect hardware connections.
3) Ensure you're using the correct COM port and a high-quality data transfer cable.
4) Try reinstalling the Mission Planner drivers and restarting your computer.
You can refer to the attached video for more details.
Refer:
https://www.youtube.com/watch?v=CEqnICe5BIc