Pixhawk controller disconnect by itself

Subscribe to the forum to receive notifications about new posts.
Post Reply
Suhas
Posts: 7
Joined: Wed Jun 26, 2024 9:52 am

Hello,
For my drone project, I'm using the Pixhawk 2.4.8 flight controller. After being connected and calibrated by the mission planner software for two to three minutes, the Pixhawk
2.4.8 controller disconnected by itself. I've given it a lot of tries, but the issue still exists. Could you please tell me the solution?
Controller - Pixhawk 2.4.8 Drone Flight Controller PX4 32 Bit Autopilot – Good Quality
Top
Ashish
Posts: 7
Joined: Mon Jul 01, 2024 12:05 pm

Hello
Please update the firmware to the latest version and try to check the mission planner log for more details like what is causing the issue to disconnect as there can be some issue with port selection or hardware.
Top
Post Reply

Return to “RC/Drone”