Need assistance for replacing throttle

[Mansi]

Hello,

I have a 3-pin throttle installed on my bicycle. I would like to replace it with Robu's throttle that comes with a display. Here is the link to the product: https://robu.in/product/electric-scoote ... -and-lock/.
Can you please provide instructions on how to make the necessary changes to my assembly?

Here are the products I currently have:

• .
  1. Controller- 24V 350Watt Brush motor controller
  2. Motor- 24V 350Watt Brush motor
  3. Battery- 8S2P 12000mAh Lifepo4 battery pack

[ironmaniac]

Hi Mansi

Can you share the model and brand of the older throttle? Maybe share some suitable photos. This will help in judging what you are trying to achieve.

[Mansi]

Sorry, I don't remember the model and brand of my throttle. You can find images below of the throttle that I have.

[Himanshu]

if your controller has support for the throttle with display then it should be easy plug and play. If you have diagrams of your controller then you can verify. I do have the same throttle like the one you have, which i have used in different project. (pottery wheel controller with: throttle, arduino nano and pwm motor speed controller)

[Mansi]

Thanks for the advice. I've just checked the controller connection cables and found that there is no connector for the display. The controller has connectors for the throttle, brake, indicator light, motor, charge port, power lock, and supply. I might need to replace the controller in order to use the throttle.