Hello Guys,
I would like to learn about interfacing the Daly USB-CAN CANbus Module with a BMS. Any suggestions would be appreciated.
Interfacing of Daly USB-CAN CANbus Module with a BMS
Hey there 
Interfacing the Daly USB-CAN CANbus Module with a BMS can be a bit tricky, but I've got some tips that might help.
First off, make sure you have the right cables and connectors. You'll need an RJ45 to RS485 adapter cable for the interface board (sometimes called the WNT board). You can usually find this on the Robu site.
Next, you'll want to check your firmware. Some BMS units have different firmware versions, and not all of them support CAN communication out of the box. You might need to update the firmware to a version.
If you're using a Raspberry Pi with Venus OS, you'll also need a CAN interface for the Pi. There's a unit called Canable that works well, but you might need to flash it with new firmware called Candlelight.
Don't forget to turn off your inverter or switch it to not being in inverter mode while you make these changes. You'll need to reset your BMS a few times during the setup.
I hope this helps! If you run into any specific issues, feel free to ask.
Interfacing the Daly USB-CAN CANbus Module with a BMS can be a bit tricky, but I've got some tips that might help.
First off, make sure you have the right cables and connectors. You'll need an RJ45 to RS485 adapter cable for the interface board (sometimes called the WNT board). You can usually find this on the Robu site.
Next, you'll want to check your firmware. Some BMS units have different firmware versions, and not all of them support CAN communication out of the box. You might need to update the firmware to a version.
If you're using a Raspberry Pi with Venus OS, you'll also need a CAN interface for the Pi. There's a unit called Canable that works well, but you might need to flash it with new firmware called Candlelight.
Don't forget to turn off your inverter or switch it to not being in inverter mode while you make these changes. You'll need to reset your BMS a few times during the setup.
I hope this helps! If you run into any specific issues, feel free to ask.
-
- Information
-
Who is online
Users browsing this forum: No registered users and 5 guests