No Video Signal After Soldering VTX and Camera

Subscribe to the forum to receive notifications about new posts.
Post Reply
User avatar
Shraddha
Posts: 61
Joined: Fri Jun 14, 2024 3:54 pm

Hi everyone,

I’m reaching out for some help with an issue I’m facing. I recently soldered my SpeedyBee TX800 5.8GHz Video Transmitter and camera Caddx Ratel 2 Upon powering it up, I plugged in my goggles and got nothing no video signal at all.
I have checked the connections and the soldering; they are solid, and there are no cold joints or bridges. I have ensured that both the VTX and camera are receiving the correct voltage. Double checked the camera settings and tested the goggles with another setup to confirm they are worked fine. Despite all this, I’m still not getting any video signal.
What else I could check or try?
Top
Post Reply

Return to “RC/Drone”