Page 1 of 1
Suggest compatible components for FPV drone under 25 thousand rupees
Posted: Fri Jul 05, 2024 11:05 am
by Shubham_S
I have a FS-i6 transmitter and its receiver (FS-iA6B), and I am looking for all other components so that I can make a FPV drone under 25,000 Rs. Please suggest.
Re: Suggest compatible components for FPV drone under 25 thousand rupees
Posted: Fri Jul 05, 2024 11:22 am
by AlamKhan
Here is the optimal configuration of components for the FPV drone build:
1) MARK5 5-inch 225mm FPV Carbon Fiber Frame in blue. (
https://robu.in/product/mark5-5inch-225 ... rame-blue/ )
2) SpeedyBee SB-F4V3-50-STACK flight controller and ESC stack. (
https://robu.in/product/speedybee-sb-f4v3-50-stack/ )
3) SUNFUN D2306 1900Kv BLDC Motors (4x). (
https://robu.in/product/sunfun-d2306-1900kv-bldc-motor/ )
4) HGLRC Zeus Nano VTX with 350mW output, compatible with 16x16, 20x20, and 25.5x25.5mm mounting. (
https://robu.in/product/hglrc-zeus-nano ... -5x25-5mm/ )
5) 5.8G UVC OTG Android AV Phone Receiver for video transmission. (
https://robu.in/product/5-8g-uvc-otg-an ... -receiver/ )
6) RunCam Racer Nano camera with 700TVL resolution and a 2.1mm lens. (
https://robu.in/product/runcam-racer-na ... -1mm-lens/ )
7) Avatar VTX antennas (2 pieces). (
https://robu.in/product/avatar-vtx-antenna-2-pcs/ )
Re: Suggest compatible components for FPV drone under 25 thousand rupees
Posted: Wed Jul 10, 2024 3:06 pm
by ayush soni
do not get the sunfun motors these are worst they burn after few flight..instead get xing e proand get a minimum 800mw vtx and minimum 1000tvl cameraand the latency in phone reciver is to highso dont get it instaed get any cheap used goggles