Robu - India's Innovative Electronics Community

Hi everyone,A few months ago, I bought a K150 programmer from Robu.in, and it's been working fine for most of my projects.

However, I've run into an issue while trying to program a PIC12F508 microcontroller.The Robu.in website lists the PIC12F508 as compatible with the K150 programmer, but when I use the Microbrn software, I can't find the PIC12F508 listed in the device options.

Has anyone successfully programmed a PIC12F508 using the K150 programmer and Microbrn software?

Is there an alternative software or workaround to program this IC with the K150 programmer?

Are there specific drivers or software updates that I might be missing?

Any guidance or suggestions would be greatly appreciated!

Thanks in advance!

Programming a PIC12F508 with K150 might require workarounds:

Use alternative software like IC-Prog or PICPgm.
Update Microbrn for wider device support.
Manually configure settings if PIC12F508 isn't listed.
Install latest K150 drivers.
Check community forums for specific guidance.