No Video Signal After Soldering VTX and Camera
Posted: Thu Nov 07, 2024 9:29 am
Hi everyone,
I’m reaching out for some help with an issue I’m facing. I recently soldered my SpeedyBee TX800 5.8GHz Video Transmitter and camera Caddx Ratel 2 Upon powering it up, I plugged in my goggles and got nothing no video signal at all.
I have checked the connections and the soldering; they are solid, and there are no cold joints or bridges. I have ensured that both the VTX and camera are receiving the correct voltage. Double checked the camera settings and tested the goggles with another setup to confirm they are worked fine. Despite all this, I’m still not getting any video signal.
What else I could check or try?
I’m reaching out for some help with an issue I’m facing. I recently soldered my SpeedyBee TX800 5.8GHz Video Transmitter and camera Caddx Ratel 2 Upon powering it up, I plugged in my goggles and got nothing no video signal at all.
I have checked the connections and the soldering; they are solid, and there are no cold joints or bridges. I have ensured that both the VTX and camera are receiving the correct voltage. Double checked the camera settings and tested the goggles with another setup to confirm they are worked fine. Despite all this, I’m still not getting any video signal.
What else I could check or try?