Robu - India's Innovative Electronics Community

Hello,

I am facing the issue with K150 programmer.

When I tried the program I am getting "The board is not responding about to apply reset....." error. I am confused whether the error is related to programmer or controller itself.

Could you please help me with this?

The board is not responding about applying reset." message is a common issue with the K150 programmer.
Here are a few steps you can try to troubleshoot the problem:
1. Verify that the correct drivers for the K150 programmer are installed on your computer. Sometimes, reinstalling the drivers can resolve the issue. You can refer to: https://www.phippselectronics.com/supp ... i1072218/
2. Here are a couple of resources that might be useful:
https://www.youtube.com/watch?v=2BvP0UlQvz8
https://www.youtube.com/watch?v=0oyCJ0UmDg4

Hope this information helps you!